Kenwood TS-430S Used Price & Fair Market Value

~$340
Fair market value
$340 (median of recent sales)
Typical range
$200 – $400
Based on
15 sold listings
Last updated
November 5, 2026

Values are estimates from recent comparable sales — condition, accessories, and included extras vary. Always compare before buying.

Selling your Kenwood TS-430S? Run its Rig Check → Answer the questions a sharp buyer will ask and get a condition report for your listing — a fully answered report lets a truly nice radio demand a good price.

TS-430S price history

$218$261$303$346$389 Feb '26 Nov '26 $250

Median sold price per month from 15 sold listings (Feb '26–Nov '26). Down ~29% over the period.

Recent sold listings

Date soldItemPriceStatus
Nov 2026Kenwood TS-430S$250SOLD
Oct 2026Kenwood TS-430S$357SOLD
Oct 2026Kenwood TS-430S$380SOLD
Oct 2026Kenwood TS-430S$340SOLD
Oct 2026Kenwood TS-430S$399SOLD
Oct 2026Kenwood TS-430S$350SOLD
Sep 2026Kenwood TS-430S$200SOLD
Sep 2026Kenwood TS-430S$265SOLD
Sep 2026Kenwood TS-430S$280SOLD
Sep 2026Kenwood TS-430S$400SOLD
Aug 2026Kenwood TS-430S$300SOLD
Aug 2026Kenwood TS-430S$270SOLD
Aug 2026Kenwood TS-430S$340SOLD
Aug 2026Kenwood TS-430S$375SOLD
Feb 2026Kenwood TS-430S$350SOLD

Live TS-430S deals

No live below-market deals on this model right now — the good ones sell fast. Get the daily digest and you’ll see the next one before anyone else.

About the Kenwood TS-430S

The Kenwood TS-430S is an all-solid-state 100-watt HF transceiver from 1983, one of the most common used HF rigs on the market four decades later. It transmits on all amateur bands from 160 through 10 meters including the then-new WARC bands, and its receiver covers 150 kHz to 30 MHz continuously — general coverage, which was still a novelty in an early-80s rig. Eight memory channels, dual digital VFOs, IF shift, a speech processor, and an AF notch filter fill out a front panel owners still praise for having everything where your fingers expect it. FM came via an optional FM-430 board, not standard. It suits bargain hunters wanting a first HF rig at the $300–$350 level, backup-rig buyers, and vintage fans who value repair documentation — eHam reviewers have called it "probably the best buy in a used HF radio," and owners keep them for decades. The trade-off is an analog-era radio with no computer control at all: no CAT, no keyer, and a notch filter at the audio stage rather than the IF. For digital modes you run a sound-card interface (SignaLink via the mic jack is the documented route) with manual frequency and mode setting — and it works fine on FT8 that way. When buying used: the signature fault is the "dots" display — rows of dots (or a single digit) on some bands, often after warm-up, meaning the PLL/VCO is out of lock. Test every band cold AND warmed up, and listen for the all-too-common dry solder joints, especially on the PA board (very early units even had finals riveted rather than soldered). If the display reads 14.000.0 MHz USB at power-on with memories gone, that's the dead lithium backup battery — a known, cheap-ish fix, but budget for it. Age-related recapping is routine at 40 years old; sellers sometimes tout the stock YK-88S SSB filter as an "optional extra" to bump the price (it came in every unit); and many 430s were modified for 11-meter CB over the years — per the standing rule, 11-meter conversions are disqualifying.

Common questions

My TS-430S powers up with a totally blank display and no receive — but if I hold A=B while powering on, it works fine. I have to do this every time. What's the fix?

Replace the lithium memory-backup battery (Kenwood part W09-0515-05). The manual itself says a 14.000.0 MHz USB display at power-on signals the battery needs replacement, and the forum replies converged on the dead battery preventing the CPU from initializing properly.

Can the TS-430S run FT8, and why would output power drop intermittently after several contacts?

Yes, it runs FT8 — the radio has no CAT control, so operators use a sound-card interface with manual frequency and mode setting. The intermittent power drops are the known PA-board cold-solder-joint fault showing up under FT8's continuous high duty cycle, as heat expands the cracked joints: the fix is resoldering the PA board.

I'm shopping used Kenwood HF rigs on a ~$450 budget — TS-430, TS-440S/440SAT, TS-850. Which should I buy?

From experienced owners: when working, the 430 is "a great little rig," but good ones are getting harder to find and several needed full PA-board solder rework. The 440 is a classic with a similar receiver but known keypad/display problems, and its built-in tuner's only okay. The consensus: any of them is a keeper if it "has had an easy life" and all should be $450 or less in excellent condition; the TS-850 is the step up if your budget stretches.

Get TS-430S deal alerts

Join the daily digest — one email a day when new below-market bargains are posted, including the Kenwood TS-430S. No spam, unsubscribe anytime.

Other Kenwood equipment